Aqara Presence Sensor FP2

The Aqara Presence Sensor FP2 support s Wi-Fi with 2.4GHz IEEE902.11b/g/n protocol, and does not support 5GHz Wi-Fi

Aqara Presence Sensor FP2 is a Wi-Fi device, it can connect to the Aqara Home app directly without an Aqara hub

Aqara Presence Sensor FP2 can detect the presence or absence of people, falls , entries, exits, approaching, going away and illuminance, and support s real-time tracking of multiple targets and zone settings.

The detection area facilitates user s to configure zone automation. 320 cells are provided, so that users may freely select the zones as the trigger areas of automation event s, such as setting the sofa, bathroom, study, and dining table. Once the zone is set, it will be added to the automation conditions; 30 zones are supported at most.

The sticker s are mainly used to facilitate user reference so that users know more accurately where the target is located. The stickers only affect the user’ s subjective judgment and do not affect the device’ s detection performance.

Yes, it support s tracking three targets.

The Aqara Presence Sensor FP2 uses millimeter-wave technology, which is sensitive to moving objects. The more marks set, the more ac curate detection the sensor can make.
1) Interference: Living and office spaces often have moving targets such as curtains , fans, green plants moved by wind, and clothes hanging. If these sensors faces these objects , a false alarm may easily occur, so it needs to be mar ked as an interference source. Currently, the interference source marking is mainly for object s with smaller emission signal s, such as green plant s and running water.
2) Edge: The setting of the edge is mainly used to counteract false targets caused by a wall or other object reflection signals. The area out side the wall is also suggested to be set as the edge.
3) Entrance and Exit: It can accelerate target creation and deletion speed and improve the user experience.

1) Press and hold for 10 seconds to reset the network.

2) Press it quickly 10 times to res tore the factory settings. Note: This operation will delete al l the data such as the Edge, Interference and Entrance and Exit.

Yes, but it requires the latest firmware Aqara hub which connected the same LAN with the Aqara Presence Sensor FP2 to supports Wi-Fi local automation.

It is recommended that the distance between the FP2 and the hub should not exceed 20 meters, and they should be under the same AP. There shall be no more than two walls between them.

1) After binding success fully, if the device homepage can display a small icon of a per son, and the motion path is consistent with yours, it represents that the device may normally report the location data. (Note: There will be a delay in device display, due to the communication between the device and the server.)

2) If absence detected within 30 seconds after leaving the detection area, it means that the current installation position of the device can meet the main requirements . The quicker it is, the less interference there are, and the easier it is to make a correct judgement. If absence event takes a longtime or not reported, it represent s that there are some interference in the space; the environment may be checked, and the position may bechanged.3) When it is installed, please avoid moving object sand moving object s within a certain period to avoid false alarms .

When wall-mounted, the horizontal detection angle is 120 degrees, and the radial di stance is about 8meter s. When ceiling-mounted at a height of 2.8meter s, it can cover a radius of 2 meters.

After setting up the zone, the automation condition will add zone detection, which supports zone automation. For example, if you setup a sofa area, you want to set up the l ight to turn on when entering the sofa zone: Cl ick the “+ ” in the upper right corner of the automation page, select FP2>Zone Detection> Zone > Enter in the “IF” section, and select the light> Light in the “Then” section to complete the automation setting.